Samsung AVMKH020EA4 - The Setting of Indoor Address and Option Switch

13-4Samsung Electronics
13-2 The setting of indoor address and option switch
■ MAIN ADDRESS SETUP
1. The main switch(SW01,SW02) is a basic address for the communication between indoor unit and outdoor unit.
The products operate normally when this address is set.
2. The address is set from 00 to 39 by the combination of SW1 and SW2.
It is impossible to have a same address from 0 to the last.
3. Before the installation of indoor unit, mark the address of indoor unit onto the drawing for address setup.
■ RMC ADDRESS SETUP
1. SW03 RMC switch is an address setup switch to control the indoor unit operation by the wired remote control and centralized
controller.
2. If the wired remote control and centralized controller is used, SW03 K1, K2 switch setup should be needed.
3. SW03 RMC switch setup is not needed when the wired remote control and centralized controller is not used.
Note : • PCB type may be different according to the model
SW01 SW02 SW04 SW05 SW06RMC
K2K1 K3 K4
K5 K6 K7 K8
K9
K10
SW01 SW02
0, 1, 2 ~ 9
0, 1, 2 ~ 9
00 ~ 09
10 ~ 19
Indoor unit
Address
SW01 SW02
0, 1, 2 ~ 9
0, 1, 2 ~ 9
20 ~ 29
30 ~ 39
Indoor unit
Address
24103A(1)_2 12/23/05 12:57 PM Page 12-13