Samsung Electronics
Service Manual
Troubleshooting
7-18
Jam0 In Tray1
Jam0 In Tray2
Jam0 In MP Tray
A paper jam has occurred in or near
the indicated tray.
Remove the jammed paper from the corre-
sponding tray.
Message Status Check or Actions
Jam
In Exit Area
A paper jam has occurred in the paper
exit area.
Remove the jammed paper from the printer.
Jam
Inside Printer
A paper jam has occurred inside the
printer.
Open the access door and remove the
jammed paper from the printer.
Load
[Size] In Tray1
Load
[Size] In Tray2
Load
[Size] In MP
The paper size specified in the
printer properties does not match the
paper you are loading.
Load the correct paper in the tray.
Low Density The amount of the toner which is
spread on the paper transfer belt for
adjusting auto color registration is
very small, so that the printer does not
recognize the toner during auto color
registration.
Replace the toner cartridge(s) with a new one.
Main Motor
Error
A problem has occurred in the
development motor of the printer.
Unplug the power cord and plug it in again.
Memory
Overflow
The printer does not have enough
memory to print the current job.
An error has occurred in the firmware
program of the printer.
The job automatically clears and the printer
returns to Standby Mode.
Lower the print resolution and try again.
Paper Empty
[Size] In Tray1
Paper Empty
[Size] In Tray2
Paper Empty
[Size] In Mp
Paper Empty
[Size] In Manual
The paper tray has run out of paper. Load paper in the paper tray.
Press Continue Button The printer is waiting for the user’s
action before printing from the
Multi-purpose Tray using the manual
feed mode.
Load a sheet of print material and press the
On Line/Continue button. You need to press
the button for each page.
To Next Page
Loading...
