Samsung CLX-6220FX - Page 89

Alignment & Troubleshooting
Service Manual
4-19
Samsung Electronics
Code LCD display Meaning Default Min. / Max Description
109-0130 0130-Thick
Temp
Media type offset
for fuser roller
temperature.
0 -10 ~ 0 1. Description
: As (-) value increases, fusing temperature goes
down in thick mode.
2. Symptom
: Hot offset takes place, or printed paper is too hot
when thick paper is printed.
※ Hot offset : When Fusing temperture is too
high, printed image appears again in 95mm
cycle
3. Solution
: Drop Fusing temperature by increasing (-) value.
110-0040 0040-LD
Power Y
Yellow LD Power at
Normal Speed
0 -10 ~ +10 + : Image Density increase
- : Opticla Density decrease
110-0050 0050-LD
Power M
Magenta LD Power
at Normal Speed
0 -10 ~ +10 + : Image Density increase
- : Image Density decrease
110-0060 0060-LD
Power C
Cyan LD Power at
Normal Speed
0 -10 ~ +10 + : Image Density increase
- : ImageDensity decrease
110-0070 0070-LD
Power K
Black LD Power at
Normal Speed
0 -10 ~ +10 + : Image Density increase
- : Image Density decrease
112-0000 0000-ACR
condition
All Condition of ACR
On/Off
On On/Off On : ACR will be executed when environment
changes.
Off : ACR will be not executed in spite of
environmental changes.
※ ACR means Auto Color Registration.
112-0115 0115-Fuser
Motor Speed
Fuser Motor Speed
For Regi.
0 -10 ~ +10
(step : 2)
+ : Fuser motor speed increase
- : Fuser motor speed decrease
112-0116 0116-Feed
Motor Speed
Feed Motor Speed
For Regi.
0 -10 ~ +10
(step : 1)
+ : Fuser motor speed increase
- : Fuser motor speed decrease