Samsung Control Unit - Operating Advanced Function; Setting the Time

22_ Operating advanced function
Operating advanced function
SETTING THE TIME
Your monobloc unit contains a clock used to start and stop the unit automatically at a given time.
You must set the time when you purchase the monobloc unit or reset this system.
1. Push the Set button for 3 seconds.
 •Mode:Normaloperation.
 •Whensettingthetime,youcanonlyuseUp,
Down, Set, Cancel/Delete button.
 •Tocancelthesetting,presstheCancel/Delete
button.
2. Set the day by pressing Up or Down button.
 The ‘day’ indicator will blink. Set the day and press Set
button to save the setting.
3. Set the hour by pressing Up or Down button.
 The ‘hour’ indicator will blink. Set the hour and press
Set button to save the setting.
4. Set the minute by pressing Up or Down button.
 The ‘minute’ indicator will blink. Set the minute and
press Set button to save the setting.
 After setting the minute, the operation returns to normal.
RC120MHXGA_IB_E_34412A(1).indd 22 2012-02-08 오후 2:35:42