■ CRT Drive
This supplies the final R/G/B signal from the F-Box and the CRT deflection signal to the CRT
9-4-2 Names & Roles of Key Parts
* GT503, GT504, GT505, GT506 : This is a port for countermeasures against compulsory discharges and is connected to the
Power Board.
* GT503, GT504 : This is a port connected to the TBC-Wire and plays the role of CRT ground.
* CNC01 : This is a port to receive the R/G/B output signals from the System Board.
* CNC02 : This is a port that receives power for the CRT and AMP from the Deflection Board.
* FV1 : A port to connect the VM signal to the DY Ass'y.
* FN1 : A port to connect signals to the Tilt Coil and is required for the screen slant adjustment.
To Next Page
Loading...
