• TYPE A
• TYPE B
Check the water level
Test button
Feeler Arm
Test button
Feeler Arm
1. Lift up the cover and pull the ice maker out of the freezer drawer.
1. Lift up the icemaker bucket and gently pull out of the refrigerator.
SETTING UP THE REFRIGERATOR
Now that you have your new Refrigerator installed in place, you are ready to set up and enjoy the
features and functions of the appliance.
By completing the following steps, your Refrigerator should be fully operational. If not, first check
the power supply and electricity source or try the troubleshooting section at the back of this user’s
guide. If you have any further questions, contact your Samsung Electronics call center.
1. Place the Refrigerator in an appropriate location with reasonable clearance between the wall
and the Refrigerator. Refer to installation instructions in this manual.
2. Once the Refrigerator is plugged in, make sure the interior light comes on when you open the
doors.
3. Set the Temperature control to the coldest temperature and wait for an hour. The Freezer will
get slightly chilled and the motor will run smoothly.
4. After powering the Refrigerator, it will take a few hours to reach the appropriate temperature.
You can store food and drinks in the Refrigerator after the temperature is sufficiently cool.
• When you have not used the Ice maker for a while, or you have opened the Freezer door
frequently, the Ice may stick together. If this has occurred, empty the ice container or break up
the ice with a wood kitchen tool. Do not use sharp items such as knives or forks.
• Do not press the test button continuously when the tray is filled with ice or water as illustration
below. Water may overflow or ice jamming may occur
18_Setting Up
Setting up your French Door
Refrigerator
CAUTION
To Next Page
Loading...
Need help?
General
