Samsung
DCS-408 & 408i Keyphone System Installation Manual
ā 7 ā
Procedure for Removing the Covers
The system cover comprises a front cover and a side cover. Refer to the diagram below to
remove the covers.
Q Removing the Side Cover
Viewed from the top, the small cover on the right-hand side is the side cover. A round indent
in the side cover is marked PUSH. To remove the side cover, push it to the right while gently
pressing the indent.
Q Removing the Front Cover
After removing the side cover, loosen the four screws holding the front cover, as shown. Two
are located under the side cover and two are on the base of the unit. After removing the
screws, hold the sides of the front cover and pull gently to remove it.
To Next Page
Loading...
