Samsung DCS-408i - Page 16

Samsung
DCS-408 & 408i Keyphone System Installation Manual
– 10 –
2. Cut the green cable soldered to the AC INPUT, about 2~3cm (1 inch) from the soldered
end. (Fig. 2.)
Figure 2
3. Push the green cable out through the rectangular hole located near to the FRG lug
(Fig. 3) and insert the cable into the groove on the base of the unit (Fig. 4.).
Figure 3
4. Prepare an AWG 10 (2.6mm) cable for connecting to an external ground and connect it
to the ground. Insert the cable into the groove on the base of the unit and connect it to
the green cable you inserted in the groove at step 3. There are two ways to connect the
cables:
Push out cable
through hole
Rectangular hole