27
READY
Preparation
Connecting to a Power source
There are two ways in which to provide the camera with power. You can use batteries(AA Alkaline, Ni-
MH, CR-V3), or alternatively, you can use an AC(100V ~ 250V) Adapter (DC 3.3V 2.0A).
Battery condition indicator
There are 3 indicators for battery condition that are displayed on the LCD monitor.
Using the batteries
1. Open the battery chamber cover by pushing in the direction of the
arrow.
2. Insert the batteries taking note of the polarity (+ / -).
3. To close the battery chamber cover, push it until it clicks.
: The batteries are fully charged.
: Prepare new batteries.
: There is no battery capacity. Replace with new batteries.
To Next Page
Loading...
