Copyright© 1995-2012 SAMSUNG. All rights reserved. 3-173-17
Disassembly and reassembly
1. Type of lubricant
2. Instructions
<Table. 3-2 lubricant Information>
<Table. 3-3
Lubricating with Grease: Lens Base
>
CAUTION
!
※ Lubricant brand name : Kanto Kasei (http://www.kanto-kasei.co.jp/e/index.html)
Please contact us (KIHYUNG CO.,LTD Distributor) by email if you are interested in purchasing.
e-mail : keeheung2000@yahoo.co.kr
■ Anti-friction lubricant serves to prevent from the possibility of defective parts.
■ Replacement parts are required to apply the lubricant before installing the ASSY BARREL.
3-4-1 How to use the lubricant for anti-friction to the ASSY BARREL assembly.
■
HANARL is volatile product. Keep its container tightly covered.
■
Make sure to shake the HANARL well first before you use it because it has a lot of particles
in the bottom. (Otherwise it becomes ineffective.)
■
Shake the HANARL until there are no lumps at all and apply it with brush.
3-4 Reassembly of barrel
The pins that work AF Lens Lead screw with clip of AF motor.
1) Apply the Grease KG-513 to the two pins of AF Lens.
2) Do not get any Grease on the AF lens.
3) Apply a light coating of the Grease KG-513 and
make sure not to get any on the AF lens and other
components.
1) Apply the Grease NFH-743C to the lead screw
and clip of AF motor.
2) Apply the Grease RX-410 to the related parts
fo BARRIER ASSY.
Apply Grease
Apply Grease
Component Name Where to apply Name of lubricant
Lens Base Sliding contact surfaces of AF Lens. Grease KG-513
Barrier assy Related Parts Friction part and the pins RX-410
AF motor Related Parts Clip part and lead screw NFH-743C
Others components Inside and outside friction surface HANARL UD-420K
To Next Page
Loading...
