Samsung FE-R300SB - User Manual

Questions and Answers

K
Kelsey AllenSep 23, 2025
Why is the display flashing on my Samsung FE-R300SB?
- A
  Adam VillaSep 23, 2025
  If the display is flashing on your Samsung Ranges, it indicates there was a power failure. Reset the clock.
C
Craig PerryAug 23, 2025
Why won't my Samsung FE-R300SB Ranges oven turn on?
- M
  mrobinsonAug 23, 2025
  If your Samsung Ranges oven won't turn on, ensure the range is completely plugged into a live, properly grounded electrical outlet. Check for a blown fuse or tripped circuit breaker and replace or reset as needed. Also, make sure the oven controls have been set correctly and allow the oven to cool if it is too hot.
K
Kimberly GardnerAug 25, 2025
How to fix a Samsung Ranges that will not turn on?
- D
  Desiree CollinsAug 25, 2025
  If your Samsung Ranges will not turn on, ensure the power cord is plugged into a live, properly grounded outlet and check the fuse and circuit breakers. If these steps don't solve the issue, check to see if the house lights will turn on. If required, call your local electric company for service.
S
santosrebeccaAug 27, 2025
What to do if my Samsung Ranges oven control beeps and shows an F error code?
- B
  Brandon HolderAug 27, 2025
  If your Samsung Ranges oven control beeps and displays an F error code, it indicates a function error. Press the CLEAR/OFF pad and restart the oven. If the problem continues, disconnect power to the range for at least 30 seconds, then reconnect it. If the issue persists after these steps, call for service.
C
Connie FowlerAug 27, 2025
Why won't the surface units on my Samsung FE-R300SB maintain a rolling boil?
- S
  Sandra ColemanAug 28, 2025
  If the surface units on your Samsung Ranges do not maintain a rolling boil or cook fast enough, it could be due to improper cookware. Use pans that are flat and match the diameter of the surface unit selected. Also, in some areas, the power (voltage) may be low, so cover the pan with a lid until the desired heat is obtained.
R
robertramirezSep 18, 2025
How to make the oven racks slide easier in my Samsung FE-R300SB?
- N
  nicholascameronSep 18, 2025
  If the oven racks in your Samsung Ranges are difficult to slide, especially if the shiny, silver-colored racks were cleaned in a self-cleaning cycle, apply a small amount of vegetable oil to a paper towel and wipe the edges of the oven racks with the paper towel.
C
Cassidy LongSep 15, 2025
Why is there steam coming from the vent when I use the convection feature on my Samsung Ranges?
- W
  William McbrideSep 15, 2025
  This is normal.
W
williefitzgeraldSep 16, 2025
Why is there a strong odor coming from my Samsung FE-R300SB?
- J
  jonathan73Sep 16, 2025
  If you notice a strong odor from your Samsung Ranges, it is normal for the first few times the oven is used due to the insulation around the inside of the oven. This is temporary.
G
Gary SilvaSep 6, 2025
How to remove scratches from my Samsung Ranges cooktop surface?
- D
  Debra FranklinSep 6, 2025
  Scratches are not removable. Tiny scratches will become less visible in time as a result of cleaning. To avoid scratches, use the recommended cleaning procedures. Make sure bottoms of cookware are clean before use, and use cookware with smooth bottoms if you have scratches or abrasions on your Samsung Ranges cooktop surface.
T
Tasha WilliamsSep 3, 2025
Why won't my Samsung FE-R300SB oven self-clean?
- M
  Michael CareySep 4, 2025
  If your Samsung Ranges oven will not self-clean, allow the range to cool and reset the controls if the oven temperature is too high to set a self-clean operation.