Samsung FE-R300SB User Manual (English)

Questions and Answers:

T
Thomas CastanedaSep 1, 2025
How to level my Samsung Ranges?
- K
  karenmartinezSep 1, 2025
  To level your Samsung Ranges, place the oven rack in the center of the oven and put a level on the oven rack. Adjust the leveling legs at the base of the range until the oven rack is level. If the floor is sagging or sloping, contact a carpenter to correct the situation. Ensure the cabinets are square and provide sufficient room for installation. Contact a builder or installer to make the appliance accessible if the kitchen cabinets are not square and built too tightly in to the appliance. Provide sufficient space so the range can be lifted over the carpet if the carpet is interfering with movement of the range.
L
Lauren MillerAug 30, 2025
Why does my Samsung Ranges oven smoke so much when broiling?
- B
  bhowardAug 30, 2025
  Excessive smoking during broiling in your Samsung Ranges oven can occur if the control has not been set properly. Also, reposition the rack to provide proper clearance between the meat and the element and preheat the broil element for searing. Remove excess fat from the meat, cutting away fatty edges. Ensure the insert on the broiler pan is positioned correctly with ribs up and slots down. Regular cleaning is necessary to prevent grease buildup on oven surfaces.
A
Alexander CollinsAug 29, 2025
How to fix a Samsung FE-R300SB oven light that won't turn on?
- G
  Gerald BranchAug 29, 2025
  If the oven light in your Samsung Ranges won't turn on, first tighten or replace the bulb if it is loose or defective. If the issue persists, call for service, as the switch operating the light may be broken.
C
Connie FowlerAug 27, 2025
Why won't the surface units on my Samsung FE-R300SB maintain a rolling boil?
- S
  Sandra ColemanAug 28, 2025
  If the surface units on your Samsung Ranges do not maintain a rolling boil or cook fast enough, it could be due to improper cookware. Use pans that are flat and match the diameter of the surface unit selected. Also, in some areas, the power (voltage) may be low, so cover the pan with a lid until the desired heat is obtained.
S
santosrebeccaAug 27, 2025
What to do if my Samsung Ranges oven control beeps and shows an F error code?
- B
  Brandon HolderAug 27, 2025
  If your Samsung Ranges oven control beeps and displays an F error code, it indicates a function error. Press the CLEAR/OFF pad and restart the oven. If the problem continues, disconnect power to the range for at least 30 seconds, then reconnect it. If the issue persists after these steps, call for service.
K
Kimberly GardnerAug 25, 2025
How to fix a Samsung Ranges that will not turn on?
- D
  Desiree CollinsAug 25, 2025
  If your Samsung Ranges will not turn on, ensure the power cord is plugged into a live, properly grounded outlet and check the fuse and circuit breakers. If these steps don't solve the issue, check to see if the house lights will turn on. If required, call your local electric company for service.
C
Craig PerryAug 23, 2025
Why won't my Samsung FE-R300SB Ranges oven turn on?
- M
  mrobinsonAug 23, 2025
  If your Samsung Ranges oven won't turn on, ensure the range is completely plugged into a live, properly grounded electrical outlet. Check for a blown fuse or tripped circuit breaker and replace or reset as needed. Also, make sure the oven controls have been set correctly and allow the oven to cool if it is too hot.