06 TROUBLESHOOTING
Troubleshooting _63
PROBLEM POSSIBLE CAUSE SOLUTION
Display flashes. There was a power failure. Reset the clock.•
Drawer does not
slide smoothly or
drags.
The drawer is out of alignment. Fully extend the drawer and push it all the •
way in. See the page 57.
The drawer is over-loaded or the
load is unbalanced.
Reduce weight. Redistribute drawer •
contents.
Warming drawer will
not work.
A fuse in your home may be blown
or the circuit breaker tripped.
Replace the fuse or reset the circuit •
breaker.
The controls are not set correctly. See the chapter on using the warming •
drawer on page 27.
Excessive
condensation in the
drawer
There is liquid present in the
drawer.
Remove the liquid.•
Uncovered foods. Cover food with a lid or aluminum foil.•
The temperature is set too high. Adjust the temperature to a lower setting.•
Food dries out in
the warming drawer.
Moisture is escaping. Cover food with a lid or aluminum foil.•
The drawer is not fully closed. Push the drawer in until the latch engages.•
FTQ307NWGX_XAA DG68-00228A.indd 63 2009-06-30 1:55:09
To Next Page