13
Precautions
Part Material
Surface
treatment
Side key, Volume UP key/Volume
DOWN key
PC-GF20% Coating
Display (touch screen) Glass AF coating
Receiver PC sheet ―
Headphone connection jack Copper+Titanium Gold plating
Headphone connection jack
surrounding area
PC-GF10% Coating
USB Type-C connection terminal Corson Alloy Gold plating
USB Type-C connection terminal
surrounding area
PC-GF10% Coating
Speaker PC-GF10% Coating
Exterior case (side, top, bottom) PC-GF10% Coating
nanoUIM card/microSD card tray PC ―
nanoUIM card/microSD card tray
(side)
PC Coating
nanoUIM card/microSD card tray
(packing)
LSM(Silicone) ―
Rear camera surrounding area PC ―
Rear camera lens panel Glass AF coating
Flash/Light lens PMMA ―
Back cover PC Coating on the
rear surface
SIM ejector tool (sample) STS304 Barrel polishing
Do not use, store or leave the equipment in hot places (e.g.
by the re, near a heater, under a kotatsu or the bedclothes,
in direct sunlight, in a car in the hot sun, etc.).
May cause re, burns, injuries or electric shocks, etc.
Do not put the equipment into heating cooking device such
as microwave oven, IH cooker or high pressure container
such as pressure cooker.
May cause re, burns, injuries or electric shocks, etc.
Do not subject the equipment to strong forces, impacts or
vibration such as being dropped, being stepped on, or being
thrown, etc.
May cause re, burns, injuries or electric shocks, etc.
The end of the SIM ejector tool is sharp. Do not use pointed
at yourself or other people.
May cause injuries or loss of sight, etc.
Do not store the equipment in extremely humid, dusty or hot
areas.
May cause re, burns, or electric shocks, etc.
Children using the equipment should be instructed in proper
operation by an adult. Make sure they use the product
correctly.
May cause accidentally swallowed, injuries or electric shocks, etc.