Samsung GX-10 - Using the Hyper-Program Mode ( )

ŝ175Ş
Using the Mode Dial
Using the Hyper-program Mode ( )
ƈ To change the shutter speed
You can switch to Shutter Priority automatic exposure by turning the front e-dial in P (Hyper-
program) mode.
- You can only set the shutter speed to a value that is in
relation to aperture.
- If the brightness changes and the aperture value is outside
the relative range, the aperture will blink in the viewfinder
and on the LCD panel.
- Press the Green button to return to Hyper-program
automatic exposure.
ƈ To change the aperture
You can switch to Aperture Priority automatic exposure by turning the rear e-dial in P (Hyper-
program) mode.
- You can only set the aperture to a value that is in relation to
shutter speed.
- If the brightness changes and the shutter speed is outside
the relative range, the shutter speed will blink in the
viewfinder and on the LCD panel.
- Press the Green button to return to Hyper-program
automatic exposure.