Alignment & Adjustment
Samsung Electronics 3-25
3-6-3 The Illumination Adjustment
1. Remove the 14 point screws and the Bottom cover.
: TH,B,M4.L15,BLK,SWRCH18A
2. Turn off the power to put the unit into the STAND-BY mode.
Press "Mute"
→ "1" → "8" →"2" →"POWER" buttons on the
Remote Control.Select "DDP3021" and enter the Test
Pattern(DDP) Menu Press the ▲▼(Up or Down) buttons,
then press ENTER to select. Press the ▶ (Right) button until
you see the Full White picture.
3. Revolve the 2 points fine adjustment dials.
4. The 2 points fine adjustment knobs
Upper knob is for the horizontal illumination adjustment.
Lower knob is for the vertical illumination adjustment.
※ According to the white pattern of the screenwhen the those dials are revolved, find the direction of the adjustment dials.
※ Until Full White pattern without the brindle is made in the Best Illumination situation,adjust the dials delicately.
To Next Page
Loading...
