English 13
02 Connections
Connecting The Speakers
Press down the terminal tab on the back of the speaker.
Insert the black wire into the black terminal (–) and the red wire into the red
terminal (+), and then release the tab.
Connect the connecting plugs to the back of the product by matching the
colours of the speaker plugs to the speaker jacks.
1.
2.
3.
Black
Red
Connecting the wall mount
Connect the speaker cord with the colour
tube to (+), and the speaker cord without the
colour tube to (–).
Prepare screws (not supplied) that are suitable
for the hole on the back of each speaker.
See the illustrations below.
Fasten the screws to the wall, then hang the
speaker on the wall.
1.
2.
3.
Colour tube
Front left speaker (L) : White
Front right speaker (R) : Red
Center speaker : Green
Surround left speaker (L) : Blue
Surround right speaker (R) : Gray
5 mm
10 mm
Hold on the back of the speaker
30 mm
4 mm
8 to 10 mm
Depth of fastened screw
Connect the upper Speaker to the assembled Stand.
Insert another large
screw (5*15, For connecting Speaker
& Stand)
clockwise into the hole on the rear of the
speaker using a
screwdriver.
This is the appearance after the speaker is installed.
Follow this steps to install other speaker.
3.
4.
5.
5
4
3
Stand
Speaker
HT-D350_D355-TK_ENG-1228.indd 13HT-D350_D355-TK_ENG-1228.indd 13 2011-12-29 10:58:322011-12-29 10:58:32
To Next Page
Loading...
