HDMI OUT
HDMI IN
DVD or Blu-ray Player SAT (Satellite/Set top box)
HDMI IN :
Connecting to an External Component with an HDMI Cable
Connect an HDMI cable (not supplied) from the HDMI IN jack on the back of the product to the HDMI OUT jack
on your digital device.
Press the FUNCTION button to select H. IN1 or H. IN2 input.
The mode switches as follows :
BD/DVD ; D. IN ; AUX ; R. IPOD ; W. IPOD ; H. IN1 ; H. IN2 ; FM
HDMI Auto Detection Function
If you have connected your home theater by HDMI cable, the home theater's video output
automatically switches to the HDMI mode when you turn it on. For available HDMI video resolutions,
see page 32.
This function is not available if the HDMI cable does not support CEC.
HDMI connection description
- HDMI outputs only a pure digital signal to the TV.
- If your TV does not support HDCP, random noise appears on the screen.
What is the HDCP?
HDCP (High-band width Digital Content Protection) is a system for preventing BD/DVD content outputted via
HDMI from being copied. It provides a secure digital link between a video source (PC, DVD. etc) and a display
device (TV, projector. etc). Content is encrypted at the source device to prevent unauthorized copies from being
made.
CAUTION
The Anynet+ function is supported only when an HDMI Cable is connected to the HDMI OUT of the
product.
1.
2.
•
•
•
!
Connect the FM antenna supplied to the FM
ANTENNA Jack.
Slowly move the antenna wire around until you nd a
location where reception is good, then fasten it to a
wall or other rigid surface.
NOTE
This product does not receive AM broadcasts.
✎
To Next Page
Loading...
