Using buttons on the Remote Control
Press the FUNCTION button to select FM.
Tune in to the desired station.
Preset Tuning 1 : You must rst add a desired
frequency as a preset. Press the STOP (@)
button to select PRESET and then press the
TUNING/CH (
) button to select the preset
station.
Manual Tuning : Press the STOP (@) button to
select MANUAL and then press the TUNING/
CH (
) button to tune in to a lower or higher
frequency.
Automatic Tuning : Press the STOP (@) button
to select MANUAL and then press and hold the
TUNING/CH (
) button to automatically
search the band.
Setting Mono/Stereo
Press the MO/ST button.
Each time the button is pressed, the
sound switches between STEREO and
MONO.
In a poor reception area, select MONO
for a clear, interference-free broadcast.
Presetting Stations
Example : Presetting FM 89.10 into memory
Press the FUNCTION button to select FM.
Press the
TUNING/CH
(
)
button to select
<89.10>.
Press the TUNER MEMORY button.
NUMBER ashes on the display.
Press the TUNER MEMORY button
again.
Press the TUNER MEMORY button
before
NUMBER
disappears from the
display.
NUMBER
disapp
ears from the display and
the station is stored in memory.
To preset another station, repeat steps 2 to 4.
To tune in to a preset station, press the
TUNING/CH ( )
button
to select a
channel.
•
•
•
•
•
•
•
•
•
About RDS broadcasting
Using the RDS (Radio Data System) to
receive FM stations
RDS allows FM stations to send an additional
signal along with their regular program signals.
For example, the stations send their station
names, as well as information about what type
of program they broadcast, such as sports or
music, etc.
When tuned to an FM station which provides
the RDS service, the RDS indicator lights up on
the display.
Description on RDS function
PTY (Program Type) : Displays the type of
programme currently being broadcast.
PS NAME (Program Service Name) : Indicates
the name of broadcasting station and is
composed of 8 characters.
RT (Radio Text) : Decodes the text broadcast
by a station (if any) and is composed of
maximum 64 characters.
CT (Clock Time) : Decodes the real time clock
from the FM frequency. Some stations may not
transmit PTY, RT or CT information therefore
this may not be displayed in all cases.
TA (Trafc Announcement) : TA ON/OFF it
shows that the trafc announcement is in
progress.
NOTE
RDS may not operate correctly if the station
tuned is not transmitting RDS signal properly or if
the signal strength is weak.
To show the RDS signals
You can see the RDS signals the station sends
on the display.
Press the RDS DISPLAY button while
listening to an FM station.
Each time you press the button, the display
change to show you the following
information : PS NAME RT CT Frequency
•
•
•
•
•
✎
•
1
To Next Page
Loading...
