The models below support audio sync
settings. Press iPod SYNC on the remote
control to change audio delay.
Supported Models : classic/3G nano/4G
nano/120GB classic/160GB Classic/5G nano
3D Sound
You can enjoy more natural and vivid
surround sound with enriched tones by
adjusting the depth of sound using the
level options.
Off High Medium Low
NOTE
It is not available in FM or W.iPod mode.
Vertical Surround
Implementing the vertical sound eld effect, it
reinforces the sense of space for music
and movie in addition to vivid sound
tones.
Off High Low Off.
G
Viewing Photo Files
Connect a USB memory that contains JPEG
les or insert a disc that contains JPEG les.
Press the ◄► buttons to select the My
Contents, and then press the ENTER button
after press the ▲▼ buttons to select the
Photos.
Press the ▲▼◄► buttons to select the
folder you want to play, and then press the
ENTER button.
Press the ▲▼◄► buttons to select the
photo you want to play, and then press the
ENTER button.
NOTE
You can't enlarge the subtitle and PG graphic
in the full screen mode.
✎
1.
2.
3.
4.
✎
Dolby Pro Logic II Mode
You can select the desired Dolby Pro
Logic II audio mode.
Press the
PL II button.
Music
When listening to music, you can
experience sound effects as if you
are listening to the actual
performance.
Movie
Adds realism to the movie
soundtrack.
Prologic
You can listen to a 2CH sound source
in 5.1CH surround sound with all
speakers active.
- A specic speaker(s) may not
output depending on the input
signal.
Matrix
You will hear multi channel surround
sound.
Stereo
Select this to listen to sound from
the front left and right speakers and
the subwoofer only.
NOTE
Before selecting Dolby Pro Logic II mode,
connect your external device to the AUDIO
INPUT jacks (L and R) on the product. If you
connect to only one of the inputs (L or R), you
cannot listen to surround sound.
iPod SYNC
If you insert your iPod player into the
iPod Dock that has already been
connected to the system, you can the
video les in your iPod player through
the connected TV.
If the video signal does not synchronize properly
with the audio signal, press iPod SYNC on the
remote control to correct the synchronization.
NOTE
Before you can play the video les in the iPod
player, you must connect the Audio/Video
terminals of the TV to the home theater using the
Composite (A/V) cable.
✎
✎
To Next Page
Loading...
