PS
(Program
Service)
Whi
le
sear
chi
ng,
<P
S> a
ppe
ars
and
then the station names will be
displayed. <NO PS> appears if no
signal is sent.
RT
(RadioText)
While searching, <RT> appears and
then text messages the station
sends will be displayed. <NO RT>
appears if no signal is sent.
Frequency
Station frequency (non-RDS service)
About characters shown in the display
When the display shows PS,or RT signals,the
following characters are used.
The display window cannot differentiate upper
case and lower case letters and always uses
upper case letters.
The display window cannot show accented
letters, <A,> for instance, may stands for
accented <A’s> like <À, Â, Ä, Á, Å and Ã.>
PTY (Program Type) indication and
PTY-SEARCH function
One of the advantages of the RDS service is that
you can locate a particular kind of program from
the preset channels by specifying the PTY codes.
To search for a program using the PTY
codes
Before you start!
The PTY Search is only applicable to preset
stations.
To stop searching any time during the process,
press PTY SEARCH button while searching.
There is a time limit in doing the following steps.
If the setting is cancelled before you nish, start
from step 1 again.
When pressing the buttons on the primary remote
control, make sure that you have selected the FM
station using the primary remote control.
•
•
•
•
•
•
Press the PTY SEARCH button while
listening to an FM station.
Press the PTY- or PTY+ button until the PTY
code you want appears on the display.
The display gives you the PTY codes
described to the right.
Press the PTY SEARCH button again, while
the PTY code selected in the previous step is
still on the display.
The centre unit searches 15 preset FM
stations, stops when it nds the one you
have selected, and tunes in that station.
•
•
To Next Page
Loading...
