GB
CONNECTIONS
2524
Connecting Audio from External Components (Con’t)
OPTICAL : Connecting an External Digital Component
Digital signal components such as a Cable Box/Satellite receiver (Set-Top Box).
1 Connect the Digital Input (OPTICAL 1 or 2) on the Home Theater to the Digital Output of the external digital
component.
2 Press the AUX button on the remote control to select <D.IN 1>,<D.IN 2>.
■
You can also use the FUNCTION button on the main unit.
The mode switches as follows : DVD ➝ D.IN 1 ➝ D.IN 2 ➝ AUX 1 ➝ AUX 2 ➝ USB ➝ FM.
OPTICAL : Rear Panel
Optical Cable
(not supplied)
Audio Cable
(not supplied)
If the external analog
component has only one
Audio Out, connect
either left or right.
AUX2 : Rear Panel
AUX2 : Connecting an External Analog Component
Analog signal components such as a VCR.
1 Connect AUX IN 2 (Audio) on the Home Theater to the Audio Out of the external analog component.
■
Be sure to match connector colors.
2 Press the AUX button on the remote control to select <AUX2> input.
■
You can also use the FUNCTION button on the main unit.
The mode switches as follows : DVD ➝ D.IN 1 ➝ D.IN 2 ➝ AUX 1 ➝ AUX 2 ➝ USB ➝ FM.
• You can connect the Video Output jack of your VCR to the TV, and connect the Audio Output jacks of the VCR
to this product.
HT-TX500_GB-(1~45)-1009 10/19/07 3:10 PM Page 24
To Next Page
Loading...
