GB
CONNECTIONS
15
Installing the DVD player
14
1 Mount the stand on the stand base and tighten 4
screws on the bottom side of the stand base.
2 Secure the main unit by aligning 2 protruding points
on the back of the main unit with the fixing holes
on the stand.
3 Tighten 3 screws in the middle of the stand.
4 Push the cable into the cable fixing hole in the stand.
5 Open the holder cover of the round board on the
bottom of the stand and pass the cables through the
holder.
6 Squeeze the cables into the groove on the holder of
the round board.
7 Close the holder cover.
8 Open a Toroidal Ferrite Core by pulling it upward.
Wrap it around of the system connection cable so it
will be next to the DVD Player. Close it back by
pressing it all the way down until you hear a clicking
sound.
STAND
STAND BASE
STAND
• For the stand packages, refer to page 9.
• The Toroidal Ferrite Core is designed to reduce electromagnetic waves that may cause interference.
Round Table
Holder
1
2
3
4
5
6
7
8
HT-TX500_GB-(1~45)-1009 10/19/07 3:09 PM Page 14
To Next Page
Loading...
