Using the Wall Mount Kit
Model Name : HT-TX500
Insert the BRACKET-HOLDER into the back side of the product so that it fits
into 2 protruding guides, and then use 3 screws to fasten it.
Place the BRACKET-WALLMOUNT on the desired wall with the arrow facing
upward, and then fasten 4 screws to fix it.
Insert the BRACKET-HOLDER into the BRACKET-WALLMOUNT so that 4
holes of the holder fit into the latch of the wall mount.
Accessories – Please check all parts included before assembly and installation.
BRACKET-WALLMOUNTBRACKET-HOLDER
Cautions
■
Please make sure the product was secured firmly. Otherwise, it may fall from the
wall, causing injury or damage to the product.
■
Take caution not to allow children pulling out the connection cables of the wall
mounting system. The product may fall from the wall.
2
1
1
2
3
TX500_QG(wall)_GB 10/5/07 9:15 PM Page 2
To Previous Page
Loading...
