Samsung HT-TXQ120K - System Settings: Audio Timing and Testing; Setting Speaker Delay Time; Using the Test Tone Feature

50
GB
SETUP
51
Setting the Delay Time
If the speakers cannot be placed at equal distances from the listening position, you can adjust the delay time of the audio
signals from the center and rear speakers.
MOVE ENTER EXITRETURN
MOVE ENTER EXITRETURN
In Stop mode, press the MENU button.
Press the Cursor ▼ button to move to <Audio> and then press the
ENTER button.
Press the Cursor ▼ button to move to <DELAY TIME> and then press
the ENTER button.
Press the Cursor ▲ , ▼ , ◄ , ► button to move to the desired speaker and
then press the ENTER button.
Press the Cursor ◄ , ► button to set the Delay time.
You can set the delay time for C between 00 and 05mSEC and for SL and SR between
00 and 15mSEC.
Press the RETURN button to return to the previous level.
Press the MENU button to exit the setup screen.
1
2
3
4
5

Setting up the Speaker Delay Time
When 5.1CH Surround Sound is played, you can enjoy the best sound if the distance between you and each speaker is
the same.
Since the sounds arrive at the listening position at different times depending on the placement of speakers, you can adjust
this difference by adding a delay effect to the sound of the Center and Surround Speakers.
Setting CENTER SPEAKER
If the distance of Dc is equal to or longer than the distance of Df in the
fi gure, set the mode as 0ms. Otherwise, change the setting according to
the table.
Distance between Df and Dc
0.00 m 0.34 m 0.68 m 1.02 m 1.36 m 1.70 m
Delay Time
0 ms 1 ms 2 ms 3 ms 4 ms 5 ms
Setting REAR (SURROUND) SPEAKERS
If the distance of Df is equal to the distance of Ds in the fi gure, set the
mode as 0ms. Otherwise, change the setting according to the table.
Distance between Df and Dc
0.00 m 1.02 m 2.04 m 3.06 m 4.08 m 5.10 m
Delay Time
0 ms 3 ms 6 ms 9 ms 12 ms 15 ms
With 2 PLII (Dolby Pro Logic II), the delay time may be
different for each mode.
With AC-3 and DTS, the delay time can be set between 00
and 15mSEC.
The Center channel is only adjustable on 5.1 channel discs.
•
•
•
Settings (Con’t)
Ideal CENTER SPEAKER
placement
It is desirable to place all speakers within this circle.
Df: The distance from FRONT SPEAKER
Dc: The distance from CENTER SPEAKER
Ds: The distance from SURROUND SPEAKER
Ideal
SURROUND
SPEAKER
placement
Setting the Test Tone
Use the Test Tone feature to check the speaker connections.
MOVE ENTER EXITRETURN
ENTER EXIT
In Stop mode, press the MENU button.
Press the Cursor ▼ button to move to <Audio> and then press the
ENTER button.
Press the Cursor ▼ button to move to <TEST TONE> and then press the
ENTER button.
The test tone will be sent to L  C  R  SR  SL  SW in order.
If the ENTER button is pressed again at this time, the test tone will stop.
Press the RETURN button to return to the previous level.
Press the MENU button to exit the setup screen.
1
2
3
