Samsung HT-TXQ120K - System Settings: Audio Adjustments; Manual Audio Balance and Level Settings; Dynamic Range and AV Sync Adjustment

52
GB
SETUP
53
Setting the Audio
You can adjust the balance and level for each speaker.
MOVE ENTER EXITRETURN
MOVE ENTER EXITRETURN
In Stop mode, press the MENU button.
Press the Cursor ▼ button to move to <Audio> and then press the
ENTER button.
Press the Cursor ▼ button to move to <SOUND EDIT> and then press
the ENTER button.
Press the Cursor ▲ , ▼ button to select and adjust the desired item.
Press the Cursor ◄ , ► button to adjust the settings.
Press the RETURN button to return to the previous level.
Press the MENU button to exit the setup screen.
1
2
3
4
Manually Adjusting the Speaker Volume and Balance with the SOUND EDIT Button.
Press the SOUND EDIT button and then press the Cursor ◄ , ► button.
Adjusting Front/Rear Speaker Balance
You can select between 0, -6, and OFF.
The volume decreases as you move closer to –6.
Adjusting Center/Rear/Subwoofer Speaker Level
The volume level can be adjusted in steps from +6dB to –6dB.
The sound gets louder as you move closer to +6dB and quieter as you get closer to -6dB.
•
•
•
•
Settings (Con’t)
Setting the DRC (Dynamic Range Compression)
This feature balances the range between the loudest and quietest sounds. You can use this function to enjoy Dolby Digital
sound when watching movies at low volume at night.
MOVE ENTER EXIT
CHANGE EXITRETURN
In Stop mode, press the MENU button.
Press the Cursor ▼ button to move to <Audio> and then press the
ENTER button.
Press the Cursor ▼ button to move to <DRC> and then press the
ENTER button.
Press the Cursor ▲ , ▼ button to adjust the DRC.
When the Cursor ▲ button is pressed, the effect is greater, and when the Cursor ▼ but-
ton is pressed, the effect is smaller.
Press the RETURN button to return to the previous level.
Press the MENU button to exit the setup screen.
1
2
3
4

Setting the AV SYNC
Video may look slower than the audio if it is connected to a digital TV. If this occurs, adjust the audio delay time to to
match the video.
MOVE ENTER EXITRETURN
MOVE ENTER EXITRETURN
In Stop mode, press the MENU button.
Press the Cursor ▼ button to move to <Audio> and then press the
ENTER button.
Press the Cursor ▼ button to move to <AV-SYNC> and then press the
ENTER button.
Press the Cursor ▲ , ▼ button to select the AV-SYNC Delay Time and
then press the ENTER button.
You can set the audio delay time between 0 ms and 300 ms. Set it to the optimal status.
Press the RETURN button to return to the previous level.
Press the MENU button to exit the setup screen.
1
2
3
4
