Samsung HW-H20 - Rear Panel; Rear Panel Connections; Connecting your System to the Power Supply; Power Connection Procedure

Connecting your System to the Power Supply
Rear Panel
1 2 3 4 5
1. AUX IN 1 Terminal
1.
Use an Audio Cable (supplied) to connect AUX
IN 1 on the product to Audio Out on an exter-
nal analog component.
2. AUX IN 2 Terminals
1.
Use an Audio Cable (not supplied) to connect
AUX IN 2 on the product to Audio Out on an
external analog component.
• Besuretomatchconnectorcolors.
• Iftheexternalanalogcomponenthasonly
oneAudioOutjack,connecttoeithertheleft
orrightterminal.
3. SUBWOOFER Connector Terminal
4. FRONT L Connector Terminal
5. POWER SUPPLY IN
4
Before plugging your system into a main socket,
you must check the voltage.
1. Connect the AC power adaptor jack to the power supply
jack properly, and then connect the AC power adaptor
plug in the wall outlet.
• Wh
endisconnectingthepowercableoftheACpoweradaptor
fromawalloutlet,pulltheplug.Donotpullthecable.
• DonotconnectthisunitorothercomponentstoanACoutlet
untilallconnectionsbetweencomponentsarecomplete.