Samsung IPX-S300B - Page 47

Ошибка! Используйте вкладку "Главная" для применения 제목 1 к тексту, который должен здесь отображаться..
Ошибка! Используйте вкладку "Главная" для применения 제목 1 к тексту, который должен здесь отображаться.
© SAMSUNG Electronics Co., Ltd.
page 47 of 162
 Outbound CLI Name
If a SIP ISP requires some specific number for the trunk, Virtual Trunk CLI can be
used.
If this option is enabled for outbound call, an original ‘display name’ in From header
of INVITE message is replaced with the Virtual Trunk CLI for the Route.
Internal CLI Name
IPX-S300B provides Internal CLI Name, used for inbound trunk call.
It is used for subscriber or service group.
Premium CID
IPX-S300B provides supplementary information of opposite user to a FMC user.
Basically photo is delivered and additional information are possible up to 6 according to a
configuration.
Calling Line Identification (CLI)
The Calling Line Identification (CLI) service notifies the user of the caller’s phone number
and name for incoming calls.
 Calling Line Identification Presentation (CLIP)
The Calling Line Identification Presentation (CLIP) service displays the caller’s phone
number and name on the called user’s phone for incoming calls.
 Calling Line Identification Restriction (CLIR)
The Calling Line Identification Restriction (CLIR) service restricts display of the
caller information for the calls made by the user.
If a user set with CLIR calls another user set with CLIP, the calling user’s information
is restricted to the called user, as CLIR has precedence over CLIP.
 CLI Routing
The CLI routing feature allows special processing of incoming trunk calls according to
the caller number.
When entering a calling number, you can use wild cards (entered by *) to enter
multiple numbers at a time.
Incoming trunk calls with caller numbers only and without caller names can be
supported by caller name.
Incoming calls from specified callers can be rejected.
Incoming calls from specified callers can be assigned called numbers, regardless of the
called DID numbers. Called numbers can also be assigned by time period.
Time periods are defined by ring plans. For more information, see the section on ‘Ring
Plans.’