E-25
ENGLISH
INSTALLING THE INDOOR UNIT
Bio-pure Filter Installation(Optional)
(Only for MH✴✴✴FKEA)
Installing the Safety Net & Air blocking kits
(Only for MH✴✴✴FMEA)
Open the front grille by pulling the tabs on the grille.
2
Remove the front grille.
3-1 Remove the safety clips.
3-2 Open the front grille about 45° and pull it forward.
3
Insert Bio-Pure or deodorizing filter.
4
Reinstall the front grille and the safety clips.
5
Do not remove the packing from a bio-pure or deodorizing filter
until you wish to use the filter, as it will lose its properties.
NN
NN
oo
oo
tt
tt
ee
ee
The air conditioner can be fitted with a Bio-Pure or deodorizing filter to remove
minute dust particles or odours. The service life of the filter is approximately
three months depending on the time during which the air conditioner is used.
Remove the vinyl packing from the filter.
1
Bio-pure filter
Deodorizing filter
Deodorizing
filter
1
Bio-pure filter
1
Accessories
When installing the unit depending on the situation, you can fill up the air
outlet(s) with one or two (max.) air blocking kits (not supplied). Then install
the insulation to block air completely.
If the humidity goes over 65%, do not block more than 2 air blocking kits.
1
Air blocking kits
Safety net
Install the safety net after installing the connection cord and fixing
electric component box cover. For your safety, you must install the safety net.
For details about installing the panel, refer to the manual for the panel.
Fix the safety net to the electric component cover box with four screws as
indicated.
2
Uncover the wrap of safety net.
1
The electric
component box cover
The safety net
Insulation
Air blocking
kits
MH***FKEA IM_E_27682_7 9/19/04 5:53 PM Page 25
To Next Page
Loading...
