Operation Instruction & Installation
Samsung Electronics44
3-7-10 Placing the Indoor Unit in Position
Once you have checked that there are no leaks in the system, you can insulate the piping, hose and cables and place the
indoor unit on the installation plate.
1. To avoid condensation problems, place heat-resistant polyethylene foam
separately around each refrigerant pipe in the lower part of the indoor unit.
2. Wind insulating tape around the pipe, assembly cable and drain hose.
3. Place the resulting bundle carefully in the lower part of the indoor unit,
making sure that it does not jut out from the rear of the indoor unit.
4. Hook the indoor unit up to the installation plate and move the unit to the
right and left until you are sure that it is securely to place in.
5. Finish wrapping insulating tape around the rest of the piping leading
to the outdoor unit.
6. Using clamps (optionally supplied), attach the piping to the wall
wherever possible.
Installation
plate
DB98_20402A(1)_1 10/26/04 2:48 PM Page 44
To Next Page
Loading...
