Disassembly and Reassembly
63Samsung Electronics
No Parts Procedure Remark
1
2
Filter-Pre
Blower & Duct
1) Loosen 2 fixing screws of indication
part and then assemble the direction of
2 Plate-Handle places by use of screw
as shown in 2).
2) Turn the Plate Handle by hand when
removing the Filter-Pre.
3) When pulling the Filter-Pre handle,
the Filter-Pre can be assembled.
✳ Be sure to remove the cushion on the
marked part after initial installation.
(It cause the damage of noise).
1) After disassembling 9 fixing screws,
detach Ass'y Cover Bottom.
4-1-4 MH052FDEA
DB98_20402A(1)_1 10/26/04 2:55 PM Page 63
To Next Page
Loading...
