To Next PageTo Next PageWhy is the safety valve dripping on my Samsung MIM-E03CN Heat Pump?
If the safety valve of your Samsung Heat Pump is dripping, it's normal for some dripping to occur due to water expansion during heating. However, if the dripping is severe, the safety valve might need replacement. Another solution is to fit an expansion vessel.
How to fix a Samsung MIM-E03CN that is not producing hot water?
If hot water is not coming out of your Samsung Heat Pump, first, check if there is power on the power supply terminal on the thermostat. If the thermostat is set too high, reduce the setting by 5 °C and press the reset button.
What to do if my Samsung Heat Pump heating is not working?
If your Samsung Heat Pump is not heating, check if there is any power on the power supply on the connector of the heating element between black and yellow/green wires. If the power supply is OK, press the reset button on the fuse/safety cut-off.
Why is my Samsung Heat Pump water not warm enough?
If the water from your Samsung Heat Pump isn't warm enough, adjust the thermostat using a standard screwdriver. Also, check the resistance of the heating element on the connector of the heater bundle and the condition of the internal wiring. Finally, ensure the UX mixing valve is correctly adjusted to your preferred temperature.
What to do if the leak warning outlet is dripping on my Samsung MIM-E03CN?
If the leak warning outlet on your Samsung Heat Pump is dripping, check the heating element o-ring seal and all connections to ensure they are properly tightened.
What happens if the PHE Outlet thermistor is SHORT or OPEN in my Samsung Heat Pump?
If the PHE Outlet thermistor is SHORT or OPEN, error codes will be displayed on the wired remote controller.
What happens if the Zone1 Water Outlet Thermistor is SHORT or OPEN in my Samsung MIM-E03CN?
If the Zone1 Water Outlet Thermistor is SHORT or OPEN, error codes will be displayed on the wired remote controller.
What happens if the Zone 2 Water Outlet Thermistor is SHORT or OPEN in my Samsung Heat Pump?
If the Zone 2 Water Outlet Thermistor is SHORT or OPEN, error codes will be displayed on the wired remote controller.
General