Samsung MIM-H04EN - Page 13

13
ENGLISH
• A single Wi-Fi Kit can be connected to 16 indoor units at most.
• You can rename each Wi-Fi Kit via a smartphone.
However, you cannot change the names for other smart phones connected to the same Wi-Fi
adapter.
2. Use the Wi-Fi Kit settings on the dedicated installation program (S-NET pro 2) to set the tenant addresses
for each Wi-Fi Kit.
ý
þ
ÿ
Ā
ߢ࣎ťθʪϑϑϩ˵ʪࣄƊʪɇθʀ˵ࣅɵЇϩϩͱϩͱѣʒϩ˵ʪʀͱʪʀϩʪʒǮࣗçϩϑࢋ
2) One by one, select the MAC address for each Wi-Fi Kit from the list.
- You can see the MAC address on the label inside the Wi-Fi Kit.
đA࡟ǹǹǹǹǹǹǹ
3) Set the tenant address. (Unavailable, 0-F)
- Seeing the table below, enter the tenant address on the S-NET pro 2.
Tenant address θͱЇΧʀ˵ɇʪɇʒʒθʪϑϑ˙ͱθϩ˵ʪʒͱͱθЇϩϑʀͱϩθͱʪʒɵцɇǮࣗçϩ
Unavailable Controls all indoor units connected to the outdoor unit
0 Controls the indoor units with the group channel address “0"
1 Controls the indoor units with the group channel address “1"
2 Controls the indoor units with the group channel address “2"
3 Controls the indoor units with the group channel address “3"
4 Controls the indoor units with the group channel address “4"
5 Controls the indoor units with the group channel address “5"
6 Controls the indoor units with the group channel address “6"
7 Controls the indoor units with the group channel address “7"
8 Controls the indoor units with the group channel address “8"
9 Controls the indoor units with the group channel address “9"
NOTE
ki]_TW_[Y]hTW[piptuhzhGvjmG~TmGrl|luUGGGXZ YWYYTXXTYZGGG㝘㤸GXXaWWaZ\