15
ENGLISH
Item LED indication Power supply Wi-Fi connection Wi-Fi setting
ߥ Tracking completed, AP connection incomplete On Off Off
ߦ Wi-Fi modem malfunctioning Blinking Blinking Blinking
ߧ Searching AP (AP mode) On Off On
ߨ Tracking units Blinking Blinking Off
8 No unit tracked Blinking Off Off
9 Inspection of the network PBA required On Blinking Blinking
ߢߡ User authentication required (AP mode) On Off Blinking
ߢߢ Downloading Off On Off
ߢߣ Rescue mode Blinking On Blinking
ߢߤ Wi-Fi Off Off Blinking Off
* If the "Rescue mode" indication appears on the LED:
- Reset the Wi-Fi Kit using the "Reset" button, and check if "Rescue mode" turns off.
- If "Rescue mode" persists even though you tried resetting the Wi-Fi kit several times, contact a service
center.
LED display during tracking
* If communication is normal but there are only the indoor units with the central control disabled.
- Reset the central control option on the indoor units. When the central control is disabled, the indoor units
cannot be controlled with the Wi-Fi kit.
Power LED Wi-Fi connection LED Wi-Fi setting LED Time Status
Blinking Blinking Off About 10 seconds Tracking
Off On (Green) Off
Alternating every 10
seconds
Only the units with the
central control disabled
On On (Yellow) Off
Blinking Blinking Off About 10 seconds Tracking
* If no indoor unit is tracked
- Check whether the communication cables between indoor units and the Wi-Fi Kit are connected properly.
Power LED Wi-Fi connection LED Wi-Fi setting LED Time Status
Blinking Blinking Off About 10 seconds Tracking
Blinking Off Off About 10 seconds
No unit tracked. Need to
check communication
Blinking Blinking Off About 10 seconds Tracking
Initializing the user data
• To initialize the user data on a Wi-Fi Kit, press the (SW3) button inside the Wi-Fi Kit for 5 seconds. All the
indicators illuminate and the user data is deleted.
ki]_TW_[Y]hTW[piptuhzhGvjmG~TmGrl|luUGGGX\ YWYYTXXTYZGGG㝘㤸GXXaWWaZ\
To Next Page
Loading...
