U
SING
P
RINT
M
ATERIALS
3.9
3
•Load transparencies in the manual tray
with print side up
,
and the
top with the adhesive strip going first
.
Notes:
• To prevent transparencies from sticking to each other, do not let
the printed sheets stack up as they are printed out.
• Place transparencies on a flat surface after removing them from
the printer.
• Do not use transparencies that are separating from the backing
sheet.
•Load card stock
with print side up
, short edge first and
center of the manual tray.
Notes:
If you experience jams with card stock feeding, turn
the paper around and try again.
To Next Page
Loading...
