Samsung ML-331xD - Page 102

4. Alignment and Troubleshooting
4-33
Samsung Electronics
Service Manual
ML-331x/371x series
● Code
M2-1110
● Error message
Paper Jam inside machine.
● Symptom / Cause
A paper jam was detected at the feed sensor.
1. The feed sensor is defective.
2. The Regi Roller was contaminated or worn out.
3. There is some obstacles in the paper path.
4. The driving for the toner cartridge has some problem.
5. The driving for the fuser unit has some problem.
● Troubleshooting method
1. Remove the jammed paper. If the error persists, check the followings.
2. Check if the feed sensor connector is connected properly.
Feed sensor
Regi. sensor
Feed sensor
Regi. sensor
3. Check if the Regi roller is contaminated or worn out. If yes, replace it.
4. Check if there is any obstacles or contamination in the paper path. If yes, clean or remove it.
CÓPIA NÃO CONTROLADA
CÓPIA NÃO CONTROLADA