2.6 <
System setup>
Changing the font setting
Your machine has preset the font for your region or country. If you want
to change the font which you prefer or set the font under special
condition such as the DOS environment, you can change the font setting
as follows:
1 Press Menu on the control panel until you see Emulation feature.
2 Press OK to access the font setting.
3 Press the left/right arrow until Setup displays.
4 Press the left/right arrow until PCL displays.
5 Press the left/right arrow until Symbol displays.
6 Press the left/right arrow until your preferred font displays.
7 Press OK.
8 Press Stop to return to machine ready mode.
Note
Following information shows the proper font list for
corresponding languages.
• Russian: CP866, Cyrillic
• Hebrew: 15Q, 8H, 0H (Israel only)
• Greek: GREEK, PC737
• Arabic & Farsi: ARABIC8, WINARABIC, PC864, FARSI,
ISOARABIC
• OCR : OCR-A, OCR-B
To Next Page
Loading...
