4.3 <
Network setup(ML-3471ND only)>
Configuring EtherTalk
EtherTalk is AppleTalk used in an Ethernet network. This protocol is
widely used in Macintosh network environments. To use EtherTalk, take
the following step:
1 Press Menu until Network appears on the bottom line of the
display and press OK.
2 Press the scroll buttons until EtherTalk appears and press OK.
3 Press the scroll buttons until On appears and press OK.
4 Press Stop to return to Standby mode.
Setting Ethernet speed
You can select the communication speed for Ethernet connections.
1 Press Menu until Network appears on the bottom line of the
display and press OK.
2 Press the scroll buttons until Ethernet Speed appears and press
OK.
3 Press the scroll buttons until the speed you want appears and
press OK.
4 Press Stop to return to Standby mode.
Restoring the network configuration
You can return the network configuration to its default settings.
1 Press Menu until Network appears on the bottom line of the
display and press OK.
2 Press the scroll buttons until Clear Setting appears and press OK.
3 Press OK when Yes appears to restore the network configuration.
4 Power the printer off and back on.
Printing a network configuration page
The network configuration page shows how the network interface card
on your printer is configured.
1 Press Menu until Network appears on the bottom line of the
display and press OK.
2 Press the scroll buttons until Network Info appears and press OK.
3 Press OK when Yes appears.
The network configuration page prints out.
To Next Page
Loading...
