Samsung ML-3471ND/XAX - Exit Roller; Pick up Gear Assy & Solenoids

Disassembly and Reassembly
Samsung Electronics
Service Manual
3-27
3.23 Pick Up Gear Ass'y & Solenoids
1. Before you remove the Pick Up Gear Ass'y &
Solenoids, you should remove:
- Duplex Guide Housing (Refer to 3.18)
- Feed Bracket Unit (Refer to 3.22.5)
2. Release the Pick Up Gear Ass'y and Pick Up Gear
Shaft, as shown below.
3. Remove the two screws securing the Manual
Solenoid and Feed Solenoid and then remove the
Solenoids, as shown below.
Pick Up Gear Ass'y
Pick Up Gear Shaft
Feed Solenoid
Manual Solenoid
3.24 Exit Roller
1. Before you remove the Exit Roller, you should
remove:
- Top Cover (Refer to 3.7)
- Side Cover (Refer to 3.9)
- Fuser Drive Ass'y (Refer to 3.15)
2. Remove the Exit Gear, and release the Bearing at
one end then remove the Roller Exit F/Down and
Exit Roller Rack, as shown below.
1
2
1
Exit Gear
Roller Exit F/Down
Exit Roller Rack
Bearing