Service Manual
Troubleshooting
6-21
Samsung Electronics
1. Open the top cover.
2. Pull the toner cartridge out.
Caution : • Avoid reaching too far into the printer. The
fusing area may be hot.
• To prevent damage to the toner cartridge,
do not expose it to light for more than a few
minutes. Cover it with a piece of paper, if
necessary.
• Do not touch the green surface underside of
the toner cartridge. Use the handle on the
cartridge to avoid touching this area.
3. Thoroughly shake the cartridge 5 or 6 times to distrib-
ute the toner evenly inside the cartridge.
Note : If toner gets on your clothing, wipe it off with a
dry cloth and wash clothing in cold water. Hot
water sets toner into fabric.
4. Hold the toner cartridge by the handle and slowly
insert the cartridge into the opening in the printer.
Tabs on the sides of the cartridge and corresponding
grooves within the printer will guide the cartridge into
the correct position until it locks into place completely.
5. Close the top cover. Make sure that the cover is
securely closed.
6.5.2 Redistributing toner cartridge
When the toner cartridge is near the end of its life:
• White streaks and light printing occur.
• Toner Low appears on the display.
• The Smart Panel program window appears on the computer telling you that the toner level is low.
• The Status LED blinks red. If this happens, you can temporarily reestablish print quality by redistributing the remaining
toner in the cartridge. In some cases, white streaks or light printing will still occur even after you have redistributed the
toner.
To Next Page
Loading...
