5
English
5
Installation
Wired Remote Controller Installation
1
Push the two hooks at the bottom of your Wired Remote Controller at the same time, and then pull up the
front cover to separate it from the rear cover.
࢘ťЇϑ˵ϩ˵ʪϩиͱ˵ͱͱϑɇϩϩ˵ʪϑɇʪϩʪࢋ
NOTE
• Insert a flat head screwdriver into the square groove in the upper area of
the hook to disassemble it easily.
2
Arrange the power cable and the communication cable so that they fit in the housing along the edges of the
rear cover.
<When the cable is not concealed> <When the cable is concealed>
15 cm(6 inch)
10 cm
(4 inch)
If you need more space for the
wiring work, you can take it off.
To Next Page
Loading...
