Setting the Clock
For each step, you have a few seconds to set the
required options. If you exceed this time, you must
start again.
Switch the system on by pressing the 1.
POWER (
) button.
Press and hold 2. TIMER/CLOCK button and
then press the ENTER button.
Result:
"CLOCK" is displayed.
Press ENTER. 3.
Result:
The hour flashes.
Decrease the hours:
`
_
Increase the hours:
`
+
When the correct hour is displayed, press 4.
ENTER.
Result:
The minutes flashes.
Decrease the minutes:
`
_
Increase the minutes:
`
+
When the correct minute is displayed, press 5.
ENTER.
Result: " TIME" appears in the display.
The current time is now set.
`
NOTE ✎
You can display the time, even when you are using another
`
function, by pressing and hold the TIMER/CLOCK button
once.
You can also use
`
[
or
]
on the front panel instead of
buttons in step 3,4.
Timer Function
The timer enables you to switch the system on or off
at specific times automatically.
Before setting the timer, check that the current time
`
is correct.
`
For each step, you have a few seconds to set the required
options. If you exceed this time, you must start again.
If you no longer want the system to be switched on
`
or off automatically, you must cancel the timer.
Example: You wish to wake up to music every morning.
Switch the system on by pressing the 1.
POWER (
) button.
Press and hold the 2. TIMER/CLOCK button and
then press
_ or +
buttons until
TIME is
displayed.
Press the 3. ENTER ( ) button.
Result: ON is displayed for a few seconds, you can set
the timer switch-on time.
Set the timer switch-on time.4.
a Press the
_
or
+
button.
b Press the ENTER (
) button.
Result: The minutes flash.
c Press the
_
or
+
button.
d Press the ENTER (
) button.
Result: OFF is displayed for a few seconds, you
can now set the timer switch-off time.
Set the timer switch-off time.5.
a Press the
_
or
+
button.
b Press the ENTER (
) button.
Result: The minutes flash.
c Press the
_
or
+
button.
d Press the ENTER (
) button.
Result: VOL XX is displayed, where XX
corresponds to the volume already set.
Press 6.
_
or
+
button to adjust the volume level
and press the ENTER (
) button.
Result: The source to be selected is displayed.
Press the 7.
_
or
+
button to select the desired
source to be played when the system switches on.
FM (radio) :
`
a Press the ENTER (
) button.
b Select a preset station by press the
_
or
+
button
.
DVD/CD (compact disc):
`
Load one compact disc.
USB : Connect the USB device.
`
To Next Page
Loading...
