44
Using "PCoIP"
2
2 Using "PCoIP"
Power Tab
Figure 2-11: Power Configuration
OSD Screen-Saver Timeout (when not connected to a session): Connected monitors will go into
standby mode if left idle for a specified period of time (in seconds).
Enter "0" if you do not want to use the standby mode function.
Display Suspend Timeout (when connected to a session): Connected monitors will go into standby
mode if left idle for a specified period of time (in seconds).
Enter "0" if you do not want to use the standby mode function.
To Next Page
Loading...
