66
Using "PCoIP"
2
2 Using "PCoIP"
2.4.11 OSD Logo Upload
Using the OSD Logo Upload page, change the logo displayed on the Teradici OSD.
Configuring the settings
1 Set the product and PC IP addresses to enable the product to connect to the PC over a network.
2 Enter the IP address set for the product in the URL address field on the PC to access the product
administrative web page.
3 Log in (Log In) and select Upload OSD Logo. The OSD Logo Upload page appears.
(See the image below.)
4 Select a new file to replace the logo and press Upload.
Make sure the OSD logo file is a 24bpp Bitmap file that does not exceed 256 x 64 pixels.
To Next Page
Loading...
