148
3
When the le encryption authentication window
appears, select AuthenTec Fingerprint Driver,
place your nger over the ngerprint identication
sensor and push it down slowly. Alternatively, select
Integrated Password Authentication and enter the
login password.
If your ngerprint is not recognized, the ngerprint is
displayed in red in the ngerprint display window.
In this case, place your nger over the ngerprint
identication sensor again and push it down slowly until
the ngerprint is displayed in green.
4
If the ngerprint is recognized, the following window
appears.
Click OK to encrypt the le.
Right-click over a folder or le to be encrypted and select
OmniPass Encrypt File(s) from the pop-up menu. The
selected folder or le will be encrypted.
Logging into Internet Sites
You can easily login to frequently used Internet sites using
the ngerprint identication or password authentication
functions instead of entering your user ID and password.
As an example, the procedures for logging into the
Hotmail site are described below.
The following describes the procedures for registering
your user ID and password. Once the user ID and
password of a site are registered, you can login to the site
automatically.
This function is applied to some models only.
This function may not be supported for some
Internet sites.
1
Launch Internet Explorer and open the Hotmail
site. (http://www. hotmail.com) Enter your user ID
and password.
2
Right-click over the icon in the Taskbar and click
on Remember Password.
3
When the mouse pointer changes to a yellow key
icon , click the login window, but not the Sign in
button. If you wait a moment, the mail address and
password information are retrieved.