Upgrading Memory
The system’s main board has on-board memory. The memory slot is below the keyboard. To replace the memory,
rst remove the keyboard. The procedures to replace the memory are described below.
Before You Start!
Replace or install new memory only after shutting the computer down completely. Do not replace or install memory when the
computer is in Sleep mode.
Disconnect main power plug and remove the battery before continuing.
To utilize the dual channel feature, using memory modules with the same specications (of the same capacity and from the
same manufacturer) is recommended.
Only use the same type of memory as specied in the Product Specication.
Replacing the Memory
1
Remove the 9 keyboard (KBD) xing screws at the
bottom of the system.
2
Lift the keyboard slightly and turn it over on the front
part of the system.
Avoid pulling the keyboard excessively at this time as
the keyboard connector can become detached.
To Next Page
Loading...
