3
Preparations
Chapter 01
"
Contact the vendor where you
purchased the product if any
components are missing.
"
The appearance of the components
may differ from the images shown.
"
A stand is not provided with the
product. To install a stand, you can
purchase one separately.
"
Use either the back-side magnet or
the double-sided tape depending
on where you want to attach the
external ambient light sensor.
The warranty for adhesiveness of the
double-sided tape applies to rst-
time-use only.
"
The external ambient light sensor is
marked with the label on the sensor
cable.
Checking the Components
Quick Setup Guide
Warranty card
(Not available in some locations)
Regulatory guide Power cord
Batteries (AAA x 2)
(Not available in some locations)
Remote Control External ambient light sensor
External IR cable
(OM46N, OM55N x 1 / OM55N-D
x 2)
Power IN rubber
(Supported model: OM55N-D)
HOLDER-GUIDE x 2 / Screw (M3
x L6) x 4
(Supported model: OM55N-D)
Top cover
(Supported model: OM55N-D)
To Next Page
Loading...
Need help?
General
