Resetting the Picture Settings to the Factory Defaults
1 To select the desired picture mode, follow the Activating Picture Options
instructions numbers 1. (see page 25)
2 Press the ▲ or ▼ button to select Reset, then press the ENTER button.
Press the ▲ or ▼ button to select OK or Cancel then press the ENTER button.
Press the
EXIT button to exit.
➢
Each mode can be reset.
4 Press the ▲ or ▼ button to select Picture Options then press the ENTER
button.
Press the ▲ or ▼ button to select 3D Effect then press the ENTER button.
5 Press the ▲ or ▼ button to select Mode, then press the ENTER button.
Press the ▲ or ▼ button to select Off, Mode1, Mode2 or 2D Conversion
then press the ENTER button.
•
Off
:
Turns the 3D Effect function off.
•
Mode1
:
Mode 1 operates with right sync rst.
•
Mode2
:
Mode 2 operates with left sync rst.
• 2D Conversion : Provides picture converted 3D to 2D.
➢
You can choose this to watch 2D picture temporally when you feel
dizzy, but you should choose “Off” to end 3D Effect completely.
➢
If the 3D effect is not working properly, it means the Mode and 3D
glasses may not be syncing properly. To put them in sync, switch to the
other mode.
Changing the Format
Select the optimal input format to match your graphic cards or 3D Software.
See the descriptions for Steps 1 to 4 above.
5 Press the ▲ or ▼ button to select Format, then press the ENTER button.
6 Press the ▲ or ▼ button to select Checker Board, Horizontal or Vertical
then press the ENTER button.
Checker Board
If the output format of your graphic card or 3D
software is Checkerboard, select this input
format.
Horizontal
If the output format of your graphic card or 3D
software is Horizontal interleaved, select this
input format.
Vertical
If the output format of your graphic card or 3D
software is Vertical interleaved, select this input
format.
3D EffectT V
Mode :
Format :
Enter
Move
Return
3D EffectT V
Mode : Mode 1
Format :
Enter
Move
Return
Checker Board
Horizontal
Vertical
Picture OptionsT V
Color Tone : Normal
►
Size : 16:9
►
Digital NR : Auto
►
DNle : Off
►
HDMI Black Level : Normal
►
Blue only mode : Off
►
Screen Burn Protection
►
3D Effect
►
Enter
Move
Return
Off
Mode 1
Mode 2
2D Conversion
PictureT V
Enter
Move
Return
Mode : Standard
►
Cell Light 7
Contrast 90
Brightness 45
Sharpness 50
Color 50
Tint G 50 R 50
Detailed Settings
►
Picture Options
►
Reset : OK
►
PictureT V
Enter
Move
Return
Mode : Standard
Cell Light 7
Contrast 90
Brightness 45
Sharpness 50
Color 50
Tint G 50 R 50
Detailed Settings
Picture Options
Reset :OK
OK
Cancel
To Next Page
Loading...
