18
8-2. Cooling Unit
Before disassemble the cover, Should be
removed all accessories in freezer.
1) Pull the screw cap out (4 EA).
2) Remove the screws (6 EA).
3) Grasp the bottom edge of the cover, and pull it
out from the unit.
Before disassemble the cover, should be cover
evap. front.
1) Pull the screw cap out (1 EA).
2) Remove the screws (1 EA).
3) Grasp the bottom edge of the cover, and pull it
out from the unit.
4) Disconnect the sensor wire connector
and pull the cover out from the unt.
Before disassemble the cover, Should be
removed cover duct. front.
1) Remove the screws (3 EA).
2) Grasp the bottom edge of the cover, and pull it
out from the unit.
3) Disconnect the wire connector and pull the
cover out from the unt.
1) Remove the fan propeller (1 EA).
2) Disconnect the wire connector from body of
the cover.
3) Remove the screws (3 EA) and separate the
fan motor case.
4) Open the case and remove fan motor.
COVER EVAP FRONT IN FREEZER COVER DUCT REAR IN FREEZER
FAN MOTOR
COVER DUCT FRONT IN FREEZER
To Next Page
Loading...
