Samsung RS20NCSW - Disassembly of Air Damper Assembly; Removing Refrigerator Multi-Cover; Refrigerator Thermistor Removal

20
The Damper is for controlling cold air circulation.
Before disassemble the cover, Should be
removed Ass'y damper.
1) Pull the screw cap out (1 EA).
2) Remove the screws (1 EA).
3) Disconnect the wire connector of thermistor.
4) Grasp the bottom edge of the cover,
pull it down and remove it.
Before disassemble the thermistor, Should be
removed cover multi.
1) Peel off the tape on the back side cover
assembly.
2) Separate insulation of cover multi from the
cover.
3) Remove the sensor.
●After disassemble cap screw(①) disassemble the screw(② ).
●Disassemble the connectors then, pull out the damper cover(③ ) from refrigerator.
●After disassembling the screw(④) from the damper cover(③), disassemble the temperature
control part by pulling forward from the damper cover(③).
●Disassemble the screw(⑤) from the assembly part of temperature control part. And disassemble
the PBA board.
●Assembly is reverse of disassembly.
COVER MULTI IN REFRIGERATOR THERMISTOR IN REFIGERATOR
ASS'Y DAMPER